Dillon Quick-Check Wire Tension Meter (Old) Uživatelský manuál stáhnout pdf (Strana 18)

18 Quick-Check User Instructions

4. The unit is now in the Configuration mode. To see the rest of the softkeys

available in this mode, press the Right Arrow key. All the Config softkeys are

shown below.

The softkeys in the Configuration mode are Wire, Setup, Reso, Comm, Mode, Units,

Power, ChPwd, and Reset. These are described below:

Wire Press

this softkey and the wire selection screen is displayed. Choose an

existing wire to change its defining characteristics.

You have the choice of changing the Range,

which is used to set the

check-tensioning function, or the Rating, which is the maximum rating of

the cable.

Range - Us

e this item to set the parameters for the check tensioning

display. Follow the prompts to set the following:

Lower tension limit - This is the low

est acceptable force

Upper tension limit - This is the

highest acceptable force

Units - Unit of measure used in defining the tension limit

Rating - Pr

ess this softkey and you are prompted to set the ultimate rating

for the cable being used and the unit of measure for that rating.

Setup Pr

ess the Setup softkey to view the Setup softkeys. This is the same as

the Setup softkey described inTop level softkeys on pa

ge 13.

Reso Pr

ess the Reso softkey and you are prompted to enter a display, or count-

by, resolution. Choose from Low, Medium or High.

Low resolution provides the best stability and makes the displ

ay easiest to

read. High resolution provides the finest graduations, but sees greater drift

from wire creep and non-repeatability. If the reading is decreasing over

time or differing between measurements on the same line, lowering the

resolution will reduce these effects.

Comm Comm

unication output not supported at this time in the Quick-Check

Mode Pr

ess this softkey to set the display mode on power up. Choices are Last*,

Temp, Check, Avg, Peak, and Force. Use the Sel keys to display your

choice and press Enter to accept it.

Units Press

this softkey to set the following:

Unit of measure on power up

- Choices are Last*, C2, C1, N, kgf, and

lbf. Use the Sel keys to display your choice and press Enter to accept it.

C2 and C1 are custom units. If you choose to have custom units, you are

prompted to enter the number of pounds in each custom unit. The Quick-

Check will then automatically calculate correct display for the applied

force.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

Komentáře k této Příručce

Žádné komentáře

Dillon Quick-Check Wire Tension Meter (Old) Uživatelský manuál Strana 18

Komentáře k této Příručce

Související produkty a manuály pro Měřící nástroje Dillon Quick-Check Wire Tension Meter (Old)