Dillon Quick-Check Wire Tension Meter (Old) Uživatelský manuál stáhnout pdf (Strana 11)

Quick-Check User Instructions 11

3 Operation

Typical operation of the Quick-Check is covered below, followed by explanations of the

various display modes, how to change wire size, how to change the unit of measure,

etc.

3.1 Typical Operation

To perform a typical tension measurement, see the note below and follow these steps:

Take readings at three different places along the cable, moving the tension meter at

least four inches for each reading. Take the average of the readings. The built-in

average function is ideal for this task.

The handle quick release pin should be used when the Quick-Check is attached to a

cable that will be de-tensioned and re-tensioned. The pin prevents the handle from

opening once the tension falls to a small level. The pin should also be used if the

Quick-Check will be installed for a prolonged period.

1. Turn the unit on by pressing the ON/OFF key…

The display shows DI

LLON briefly, then, in this example, the screen

shows the following:

Figure 3.1 Sample display

Press the WIRE key to list the stored calibrations.

2. This example shows the wire is a 7/16”, 6X19 stranded cable and the unit of

measure is lbf. Place the Quick-Check so the two outside sheaves hang on the

wire. Insure that the wire rope is riding in the groove of all three sheaves. See

Figure 3.2. Press the Ze

ro softkey to zero the display.

should be displayed.

3. Raise the lever arm until it locks in the upright position to apply tension to the

wir

e. Read the line tension on the display.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Žádné komentáře

Dillon Quick-Check Wire Tension Meter (Old) Uživatelský manuál Strana 11