Dillon EDXtreme (Red) Uživatelský manuál stáhnout pdf (Strana 44)

EDXtreme User Instructions 43

There are three soft keys on the first display and four on the second display. The soft

key functions are described below:

Units Changes the displayed unit of measure. Each press advances the display

through this sequence; lbf, kgf, N, custom 1, custom 2.

Print Outputs serial data to peripheral devices attached to COM 1.

Clr.All Clears the peaks on all EDXs currently in communication with the remote.

Clear Clears the current peak value of the active EDX.

UZ.All Resets all EDXs to calibration zero reference point.

Z.All Zeros all EDXs currently in communication with the remote.

Setup Accesses the Setup menu shown in Figure 6.1.

Config Accesses the Config menu shown in Figure 6.3.

6.2 Communicator Setup Menu

The Communicator Setup menu can be accessed using the softkey or the Remote

Setup hardkey. Press the right Arrow key to access the Setup menu softkey.

Figure 6.1 Communicator Setup Menu

Setup

PtFmt Misc About Test

Batt Disp Keys Comm Ntwrk

Cell Com 1

Press KEY to test.

Press ESC key to

exit

Run display test

View Battery

Voltage and temp.

About

Display Device

info, SN, FW and

Flash Contr BLite

Inten Mode

Selected Backlight

ON, OFF or Timer

operation

If Timer enabled

then: Enter time in

Seconds

Choose Motion

Reset Timer: YES

or NO

Choose backlight

intensity: 1- 10

Adjust Contrast

Up or DOWN

Enable Key Blink/:

YES or NO

Choose default

print format: 1 - 5

Run network test

Continued on

the next page

Date/Time

(Enabled,

Disabled)

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 66 67

Komentáře k této Příručce

Žádné komentáře

Dillon EDXtreme (Red) Uživatelský manuál Strana 44

Komentáře k této Příručce

Související produkty a manuály pro Měřící nástroje Dillon EDXtreme (Red)